Hello Gustin, I looked at my printers.conf file and printers.conf.o and here is what I found:
For printers.conf #Printer configuration CUPS v1.1.23 #Writen by cupsd on Wednesday May 31 07:14:12 2006 <DefaultPrinter Canon BJ200e> Info CANON BJ-200 Location DeviceURI parallel:/dev/lp0 State Stopped StateMessage Accepting Yes JobSheets none none QuotaPeriod 0 PageLimit 0 Klimit 0 <printer> For Printers.config.o #Printer configuration file for CUPS v 1.1.23 #Written by cupsd on May 29 22:56:44 2006 <DefaultPrinter Canon BJ-200e> Info CANON BJ-200 Location DeviceURI parallel:/dev/lp0 State Idle Accepting Yes JobSheets none none QuotaPeriod 0 PageLimit 0 KLimit 0 <printer> I also had a look at "cups.conf" which had 819 lines most of which are comments. Among the lines which were not commented out were the following: ServerCertificate /etc/cups/ssl/server.crt which did not match the comment exactly. I also noticed a comparison which seemed strange #ImplicitClasses off ImplicitClasses on I did not have time to look at all 819 lines closely. I hope this helps. Michael Walters ____________________________________________ Gustin Johnson wrote: > -----BEGIN PGP SIGNED MESSAGE----- > Hash: SHA1 > > Your cups configuration is stored in /etc/cups/printers.conf > If you post this config here, make sure to check for usernames and > passwords, as they may exist in this file (and you probably don't want > the world at large to see them). > > You can manage your printers by clicking on Print System -> Manage > Printers in the KDE menu > > If this does no exist, you should be able to get to the same place by > clicking System Settings -> Printers > > Michael Walters wrote: >> Hello Jesse, >> >> Thanks for the suggestion for path to printcap file. That path may be >> right, but the reason I changed the path when brain dead was that the >> printer was not working, so I may have the correct path but still need >> to configure my printer. >> >> I changed the path to /etc/printcap , but need to do something else to >> get the printer working again. >> >> Thanks for all the help from everyone including Jesse. >> >> Regards, >> >> Micahel >> >> Jesse Kline wrote: >>> On Tue, 2006-30-05 at 19:19 -0600, Michael Walters wrote: >>>> What are a few possible paths to the printcap file in the print manager >>>> that I could try out to possibly get my printer configuration working >>>> again? >>> /etc/printcap >>> >>> >>> ______________________________________________ >> _____ _______________________________________________ clug-talk mailing list [email protected] http://clug.ca/mailman/listinfo/clug-talk_clug.ca Mailing List Guidelines (http://clug.ca/ml_guidelines.php) **Please remove these lines when replying
