In the bottom of Modules/Platform/Windows.cmake: # uncomment these out to debug nmake and borland makefiles #SET(CMAKE_START_TEMP_FILE "") #SET(CMAKE_END_TEMP_FILE "") #SET(CMAKE_VERBOSE_MAKEFILE 1)
Uncomment those three SET lines to see verbose nmake output... HTH, David On Wed, Nov 4, 2009 at 5:07 PM, Dixon, Shane <[email protected]> wrote: > I added a definition using > > SET_TARGET_PROPERTIES( MyProjDLL-sw PROPERTIES > COMPILE_FLAGS "-DEMULATION_MODE" ) > > I tried to use "nmake verbose=1 MyProjDLL-sw" to watch the command-line > come by and verify it had the right definition, but all I get is this: > > C:\PROGRA~1\MICROS~1.0\VC\bin\cl.exe > @C:\DOCUME~1\SHANE~1.DIX\LOCALS~1\Temp\nm54B2.tmp > myprojdll.c > > Do I have a command-line that's too long so it has to be put into a .tmp > file? I can't find the file after the run so I'm assuming it gets deleted. > How can I see what's getting passed to cl.exe? > > -- > Shane Dixon > Linux Engineer > Atmel Corporation > > _______________________________________________ > Powered by www.kitware.com > > Visit other Kitware open-source projects at > http://www.kitware.com/opensource/opensource.html > > Please keep messages on-topic and check the CMake FAQ at: > http://www.cmake.org/Wiki/CMake_FAQ > > Follow this link to subscribe/unsubscribe: > http://www.cmake.org/mailman/listinfo/cmake >
_______________________________________________ Powered by www.kitware.com Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html Please keep messages on-topic and check the CMake FAQ at: http://www.cmake.org/Wiki/CMake_FAQ Follow this link to subscribe/unsubscribe: http://www.cmake.org/mailman/listinfo/cmake
