Hey (Kjetil)
Dunno if I should post troubles with snd-rt here on the mailing-list or
mail them directly to Kjetil, so in the meantime I'll post them here
like I did before.
If I run this code:
((lambda (hertz)
(do ((x 1 (+ x 1)))
((> x (- (/ (/ (rte-samplerate) 2) hertz) 1)))
(begin
(print x)
(<rt-out> 0 (* 0.5
(/ 1 x)
(oscil* (* hertz x)))))))
200)
everything works as expected, generating a saw-wave up to the nyquist
frequency on channel 0.
But if I want to run the same code on channel 1, the saw-wave from
channel 0 gets distorted a lot, and newly generated one is as expected.
Is there an explanatino for this kind of behaviour?
I have tried all kinds of volume levels, saw-wave levels, reversed the
channels still the result remains.
Only if I keep the number of sines generated below 40-45 then I get
acceptable results (but not acceptable saw-waves).
I do need the control over the different frequencies badly, otherwise I
would've use another saw-wave generator probably.
Thanks for looking at it.
cheers
_______________________________________________
Cmdist mailing list
[email protected]
http://ccrma-mail.stanford.edu/mailman/listinfo/cmdist
