It does get intricate! Rich
> On Oct 31, 2013, at 8:07, "[email protected]" <[email protected]> wrote: > > Thanks Rich - that answered it. Looks like G40 was used only by Acco to > designate a small link G43 chain. > > John > > > Sent from my iPad > >> On Oct 31, 2013, at 5:08 AM, Rich Knowles <[email protected]> wrote: >> >> After a bit of research I dug these resources out of the ether: >> >> http://www.peerlesschain.com >> >> http://www.1st-chainsupply.com/aboutgrading.htm >> >> http://www.jamestowndistributors.com/userportal/document.do?docId=1136 >> >> And.. I also tripped over this chart for drive belts, more useful arcane >> inanity: >> >> http://www.gates.com/catalogs/BELT%20I.D.%20CHART%202012%20SM1.pdf >> >> Interesting bathroom reading.... >> >> Rich. >> >> >>> On Oct 30, 2013, at 20:51, "[email protected]" <[email protected]> wrote: >>> >>> I'm sure I knew this at some point in my life but can anyone explain the >>> difference between G40 and G43 chain? >>> >>> Thanks >>> >>> John >>> >>> >>> _______________________________________________ >>> This List is provided by the C&C Photo Album >>> http://www.cncphotoalbum.com >>> [email protected] >> >> _______________________________________________ >> This List is provided by the C&C Photo Album >> http://www.cncphotoalbum.com >> [email protected] > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > [email protected] _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com [email protected]
