Will do. Likely have some time in the next few days. Mike
Date: Mon, 24 Mar 2014 08:38:56 -0400 From: Stevan Plavsa <[email protected]> To: Martin Mac McKenzie <[email protected]>, "[email protected]" <[email protected]> Subject: Re: Stus-List Shift cable removal 1983 C&C 37 Message-ID: <CADdEvn43bnTOiFnnbFL=uQG7=4kbvfwlkckgvw5snx6xwss...@mail.gmail.com> Content-Type: text/plain; charset="iso-8859-1" Michael, I'm going to be tackling this job on my boat this spring and my setup looks like the one in the moyer marine pic. If you have detailed instructions I would be forever grateful. Thanks, Steve Suhana, C&C 32 Toronto On Sun, Mar 23, 2014 at 9:52 PM, Martin "Mac" McKenzie <[email protected] > wrote: > Michael, > > That is pretty much my set up. My handle is a small cast piece and only > sticks out about 3 inches. > > Thanks, > > Mac > Worthy Pearl > 1983 C&C 37 > > Date: Sun, 23 Mar 2014 19:40:05 -0400 > From: Michael Brown <[email protected]> > To: [email protected] > > Subject: Re: Stus-List Shift cable removal 1983 C&C 37 > Message-ID: <[email protected]> > Content-Type: text/plain; charset="utf-8" > > > Mac, if this is what you have I can give you detailed instructions. > > http://www.moyermarine.com/forums/showthread.php?t=7005 > > I have most of mine sitting on my worktable. > > Michael Brown > Windburn > C&C 30-1 > > > From: Rick Brass <[email protected]> > To: "[email protected]" <[email protected]> > Subject: Re: Stus-List Shift cable removal 1983 C&C 37 > Message-ID: <[email protected]> > Content-Type: text/plain; charset="us-ascii" > > I'm not sure the able wii come out the bottom. On my boat the two levers > neded to be removed from the mechanism, and then the cables came out the > top after the screws retaining the cable sheaths wears removed. > > Rick Brass > > Sent from my iPad > > > On Mar 23, 2014, at 0:51, Rich Knowles <[email protected]> wrote: > > > > On mine, there is a screw through the side of the top of the tube > housing the cable that attaches the end of the cable jacket to the inside > of the tube. Check to see if you have that screw and undo it. That should > allow the cable to be pulled out the bottom of the cockpit sole. > > > > Rich > > > >> On Mar 23, 2014, at 1:22, "Martin \"Mac\" McKenzie" < > [email protected]> wrote: > >> > >> HI all, > >> > >> I have a stiff shift cable on my C&C. I have the separate shift and > throttle on either side of the pedestal guard not on the pedestal itself. > The cable runs up the stainless tube. Has any one ever tried to replace > this cable? > >> > >> I cannot figure out how the cable is attached inside the tube. I have > disconnected the shift lever so the cable is free at that end. There is no > way I can pull the cable out from underneath. > >> > >> I know it's the cable that is stiff and not the linkages or > transmission. > >> > >> Any ideas? > >> ? > > >> Mac > >> Worthy Pearl > >> 1983 C&C 37
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com [email protected]
