Joel, +1 on the West Six/10 thickened epoxy, and the PBase info.
I changed 4 cowl vents last weekend. One of them had been leaking for years apparently, so the core was wet. Very wet. I was able to scoop out the softened wood with a finger and screwdriver, dried it with everything from paper towels, newspaper, sun, air, and time. Then used the syringe to inject the epoxy into the gap between deck and liner. The result was better than I could have imagined. After letting it set, and re-drilling the screw holes that were now filled with epoxy, I installed the flashy new plastic Nicro cowls using silicone sealant. (Had it been Stainless hardware I would have used butyl tape as per PBase). I did take a few photos of the process. If anyone is interested, I will be happy to e-mail. Peter Delean 1980 C&C 30 Mk1 Penetanguishene, ON
_______________________________________________ This List is provided by the C&C Photo Album Email address: [email protected] To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
