This sounds very much like the Viking 33. Although the handrails fit onto the splash guard and I could not find any handrails to replace them with. So, I went on craigslist and found a guy selling rough cut teak boards and I made my handrails from those using the old ones as a guild for spacing and the fit up against the splash guard. I finished with 8 coats of epiphanies varnish. Please think again about the cetol. Clear varnish looks so much nicer. I just looked at a Sabre 38 where the owner finished all the exterior teak in cetol. My initial reaction to boarding the boat was disappointment... I have to say, I took so much pride in those handrails I built and finished in varnish... The only think I would have dome differently, would have been to coat 2 or 3 times with epoxy and then did the 8 coats of varnish. DannyBoatless in Massachusetts
---------- Original Message ---------- From: Burt Stratton via CnC-List <cnc-list@cnc-list.com> To: "'rick bushie'" <rickbushie...@gmail.com>, <cnc-list@cnc-list.com> Subject: Re: Stus-List teak grab rail help 35 MK I Date: Thu, 13 Nov 2014 16:32:10 -0500 I don’t have inside grab rails or a headliner for that matter. Maybe those amenities were sacrificed along with the shower and v- berth on the “custom” ¾ ton special Or maybe my headliner was removed although it seems the inside of the cabin ceiling was painted several times. The layout is so different from the 33-1 that I doubt there is any similarity in those details either. My on deck grab rails screw in from below with oval head stainless woodscrews. They came out with no problem and I refinished them in on my bench in the basement. Re-bedded with life caulk… good as new. Did the same with all my companionway teak trim. Nice that that is all the teak I have on the deck (well, except under the winches). After my last boat this is just a little piece of heaven. From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of rick bushie via CnC-List Sent: Thursday, November 13, 2014 3:19 PM To: cnc-list@cnc-list.com Subject: Re: Stus-List teak grab rail help 35 MK I Joe, I know the 30-1 isn't the same boat but Anchovy's grab rails are wood screwed from inside the cabin THROUGH the cabin grab rails. Rick Bushie Anchovy 30-1 Worton Creek, MD
_______________________________________________ This List is provided by the C&C Photo Album Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
