Just checked my can. There is no mention of what it won't stick too. "over wood, GRP, metals, concrete, or any other pre-painted surface."
I would say that if you use epoxy just make sure to wash the blush off. Josh On Jul 9, 2015 2:35 PM, "Charlie Nelson via CnC-List" <[email protected]> wrote: > As long as the Kiwi-Grip will stick to the repair (if done with epoxy w > fillers), I do not care. > > Probably need to check with Kiwi-Grip to see if its compatible. > > Thanks, > > Charlie > > [email protected] > > > -----Original Message----- > From: Josh Muckley via CnC-List <[email protected]> > To: C&C List <[email protected]> > Cc: Josh Muckley <[email protected]> > Sent: Thu, Jul 9, 2015 2:17 pm > Subject: Re: Stus-List Deck repair > > If your going to kiwi grip it anyway, why worry about gelcoat? > Josh Muckley > S/V Sea Hawk > 1989 C&C 37+ > Solomons, MD > On Jul 9, 2015 2:09 PM, "Charlie Nelson via CnC-List" < > [email protected]> wrote: > >> I managed to crush a 2" x 4" portion of my aft deck on both sides >> recently. >> >> I have cleaned out the balsa core and removed the fiberglass/gel coat >> pieces on top and need to fill it in (its about 1 inch deep) and then, >> eventually, cover it with the Kiwi Grip that >> was on it pre-crushing. >> >> I have done a lot of fiberglass construction with epoxy and thought I >> would mix up a batch with some cotton fiber filler and just fill the hole. >> >> Alternatively I could wet a bunch of fiberglass tape I have with epoxy >> and then top this off with some thickened epoxy. >> >> Then I read about gel coat repair and it says that this won't adhere to >> an epoxy repair so I maybe I should fill the holes with thickened >> gel coat so that eventually some Kiwi Grip will stick to it. >> >> I need to fill it this weekend before the balsa core gets wet from rain, >> etc. although I have put a thin coating of epoxy on the balsa to protect it >> temporarily. >> >> What advice does the list have for such a repair? >> >> TIA, >> >> Charlie Nelson >> Water Phantom >> C&C 36 XL/kcb >> >> >> >> >> >> >> >> [email protected] >> >> _______________________________________________ >> >> Email address: >> [email protected] >> To change your list preferences, including unsubscribing -- go to the >> bottom of page at: >> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com >> >> >> _______________________________________________ > > Email > address:[email protected] > To change your list preferences, including > unsubscribing -- go to the bottom of page > at:http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > > _______________________________________________ > > Email address: > [email protected] > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: [email protected] To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
