Agreed on that approach, as it is what I did on our Yanmar 3jh2e when I needed
to spin the impeller a little bit as I was removing it.
Sent from Samsung tablet.
-------- Original message --------
From: Neil Gallagher via CnC-List <[email protected]>
Date: 4/20/2017 11:48 PM (GMT-05:00)
To: [email protected]
Cc: Neil Gallagher <[email protected]>
Subject: Re: Stus-List Yanmar Hand Starting Handle
Another approach, if the front pulley is accessible, is to put a
deep socket on the nut holding the pulley to the crankshaft, then
use a socket wrench or a breaker bar to rotate the engine.
Neil Gallagher
Weatherly, 35-1
Glen Cove, NY
On 4/20/2017 6:17 PM, David via
CnC-List wrote:
<!-- P {margin-top:0;margin-bottom:0;} -->
Hello all...trying to source a hand starting handle for my
Yanmar 3qm30 so I may adjust my valves when the head goes back
on. Tried the net to no avail. Perhaps one of you has an
extra one hanging around for purchase (or short-term lease)?
Thanks in advance.
David F. Risch
(401) 419-4650 (cell)
_______________________________________________
This list is supported by the generous donations of our members. If you wish to
make a contribution to offset our costs, please go to:
https://www.paypal.me/stumurray
All Contributions are greatly appreciated!
_______________________________________________
This list is supported by the generous donations of our members. If you wish to
make a contribution to offset our costs, please go to:
https://www.paypal.me/stumurray
All Contributions are greatly appreciated!
