You can probably overdue the greasing if you installed zerk fittings and use a gun that wont happen with grease cups i find them ( my boat has 2) quite hard to turn. Cups can be refilled and i believe a zerk fitting would fit the same threaded hole the cup used
On Wed, Nov 7, 2018 at 8:19 AM bwhitmore via CnC-List <[email protected]> wrote: > I installed grease zerks with the rudder in the boat and the boat in the > water. I drilled two holes in the rudder tube, one above and one below the > autopilot arm and used a tap for the right threads to install the zincs. > Don't over tighten them. I the used Green Grease as discussed earlier. > Easy Peasy. > > Bruce Whitmore > 1994 C&C 37 / 40 + "Astralis " > > > > Sent from Samsung tablet. > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each > and every one is greatly appreciated. If you want to support the list - > use PayPal to send contribution -- https://www.paypal.me/stumurray > > -- Sent from Gmail Mobile
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
