Robbie:
Thanks. That is the inelegant solution that I knew would work when I
started this unfortunate thread. Given that no one has suggested a source
for a replacement pin, I suspect that's where I'm headed.
I appreciate everyone's input.
Matt
-----Original Message-----
From: Robbie Epstein via CnC-List
Sent: Thursday, April 11, 2019 1:04 PM
To: [email protected]
Cc: Robbie Epstein
Subject: Re: Stus-List Merriman snatch block question
Matthew,
I have four of the large Merriman snatch blocks on my boat. Over the years,
all the center shafts have failed at some point. The little screw that hold
the holds the shaft in simply isn't up to the task. If you want to fix it
for less than 5 bucks, get a 3/8" x 3 1/2" stainless bolt, which has 2 1/2'
of solid unthreaded shank for the roller to use as a bearing surface, and
cut off just enough of the threads with a hacksaw to accept a washer and
locknut. If I recall, you have to drill out one of the cheek straps to
3/8", but the other strap already has that size hole. Its not as pretty as
a the original, but it's not coming loose, and I'm guessing the snap shackle
will fail long before the shaft and cheeks.
Robbie Epstein
Thorfinn
C&C 40 TMDK
_______________________________________________
Thanks everyone for supporting this list with your contributions. Each and
every one is greatly appreciated. If you want to support the list - use
PayPal to send contribution -- https://www.paypal.me/stumurray
_______________________________________________
Thanks everyone for supporting this list with your contributions. Each and
every one is greatly appreciated. If you want to support the list - use PayPal
to send contribution -- https://www.paypal.me/stumurray
