I would give it a try. I have never used Mapp gas. You will want to use as hot of flame as possible.
On Mon, Jun 1, 2020 at 8:21 AM Josh Muckley via CnC-List < cnc-list@cnc-list.com> wrote: > You think Map gas will be good enough? > > On Mon, Jun 1, 2020, 11:17 Doug Mountjoy via CnC-List < > cnc-list@cnc-list.com> wrote: > >> Josh, >> I used to work in a machine shop where I had to remove gears off of >> shafts. We used an acetylene torch to heat the gear fast, so the shaft >> didn't expand as fast. Using a slow heat source will heat the coupling and >> shaft at about the same rate. You want to expand the coupling faster than >> the shaft expands. >> >> >> >> Doug Mountjoy >> sv Rebecca Leah >> C&C Landfall 39 >> Port Orchard yacht club >> _______________________________________________ >> >> Thanks everyone for supporting this list with your contributions. Each >> and every one is greatly appreciated. If you want to support the list - >> use PayPal to send contribution -- https://www.paypal.me/stumurray >> >> _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each > and every one is greatly appreciated. If you want to support the list - > use PayPal to send contribution -- https://www.paypal.me/stumurray > > -- Douglas Mountjoy 253-208-1412 Port Orchard YC, WA Rebecca Leah C&C LandFall 39
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray