Or would a 12 point socket work? Bill Coleman
On Thu, Sep 23, 2021, 3:35 AM Bob Tallman via CnC-List < cnc-list@cnc-list.com> wrote: > Great toy store indeed. Make sure to keep the length to a minimum to > avoid too much rocking. > For grins regarding the size, is it 7/16, or is it 1/2? > Just thinking if the measurements are in line with a ratchet drive, the > square stock could be just a double ended female and use a ratchet drive. > A socket will fit over the square shaft, and then you can use a standard > setup to crank the boom. > > Who is the manufacturer of the furling boom? > Picture or two of the interface in question? > > > On Wed, Sep 22, 2021 at 9:57 PM Dennis C. via CnC-List < > cnc-list@cnc-list.com> wrote: > >> Go to mcmaster.com and order a piece of square tubing the correct size. >> When you get it, drill holes through one end and put a screwdriver or long >> bolt through it. Use it to square up the boom. >> >> https://www.mcmaster.com/square-tubing/ >> >> -- >> Dennis C. >> Touche' 35-1 #83 >> Mandeville, LA >> >> On Wed, Sep 22, 2021 at 6:29 PM andrew_m--- via CnC-List < >> cnc-list@cnc-list.com> wrote: >> >> We recently purchased a 1974 C&C 30 mk1. Our boat has a roller furling >> boom, but didn?t come with the crank handle. Does anyone know where I can a >> get a crank handle for the roller furling boom on a 1974 C&C 30 mk1? have >> one I can borrow (we're near Victoria BC)? or know of another tool that'll >> work in place of the original crank handle? Our boom's stuck at about 30 >> degrees from where it should be and I'd love to turn it back. >> Thanks to all of the subscribers that contributed to the list to help >> with the costs involved. If you want to show your support to the list - >> use PayPal to send contribution -- https://www.paypal.me/stumurray >> Thanks - Stu >> >> >> >> -- >> Dennis C. >> Touche' 35-1 #83 >> Mandeville, LA >> Thanks to all of the subscribers that contributed to the list to help >> with the costs involved. If you want to show your support to the list - use >> PayPal to send contribution -- https://www.paypal.me/stumurray Thanks - >> Stu > > -- > Regards, > > Bob Tallman > 631.387.6748 > Thanks to all of the subscribers that contributed to the list to help with > the costs involved. If you want to show your support to the list - use > PayPal to send contribution -- https://www.paypal.me/stumurray Thanks > - Stu
Thanks to all of the subscribers that contributed to the list to help with the costs involved. If you want to show your support to the list - use PayPal to send contribution -- https://www.paypal.me/stumurray Thanks - Stu