Mixing elbow can cause problems like you experienced.
From: Robert Abbott via CnC-List <cnc-list@cnc-list.com> Sent: June-26-22 12:40 PM To: Josh <muckl...@gmail.com>; Stus-List <cnc-list@cnc-list.com> Cc: Robert Abbott <robertabb...@eastlink.ca> Subject: Stus-List Yanmar 2 GMF Bottom and prop is clean....boat is launched every Spring after Winter layup. Checked the throttle cable and that seems to be fine....most likely a fuel issue.... On 2022-06-26 11:44 a.m., Josh wrote: Is the bottom and prop clean? Jun 26, 2022 09:39:09 Robert Abbott via CnC-List <mailto:cnc-list@cnc-list.com> <cnc-list@cnc-list.com>: Went to take the boat out Friday for a short sail .....motoring out heading into a12 knt breeze....started to increase the RPM's and found the engine wouldn't rev about 2,100 RPM's ....marine diesel's are not supposed to be that complicated but they are to me. I wouldn't know where to start to trouble shoot....getting a mechanic to deal with it this week. I spoke to him and told him the situation and he thinks it is a fuel problem....engine not getting enough fuel....my fuel tank and fuel should be clean as I had the bottom of it replaced 2 years ago and the 2 fuel filters replaced. He thinks one or both of the filters are restricting the fuel flow.....I hope he is right but I don't think so. Possibly many are causes....restricted fuel injectors, fuel pump, etc. ....the engine has never been serviced in the 16 years I have had the boat Any insight or guidance to help greatly appreciated. Rob Abbott AZURA C&C 32 - #277 Halifax, N.S.
