Also, if you want to leave the lens in place, you could try small picks to remove the old caulk. Hardware stores sell them. I bought a pack of four (different configurations, such as straight, bent, hooked) for about $10.
From: Janet Schilling via CnC-List <[email protected]> Sent: Saturday, November 1, 2025 9:39 PM To: Wolford via CnC-List Matthew <[email protected]> Cc: Janet Schilling <[email protected]> Subject: Stus-List Re: Fwd: Deglazing port lights Matt: Oh my. I was hoping that I wouldn’t have to go full Monty on them. Any recommendations on removing the old caulk? Someone posted something about toothpaste but I’m not sure what it referred to. Janet Sent from my iPhone On Nov 1, 2025, at 8:39 PM, Matthew Wolford via CnC-List <[email protected] <mailto:[email protected]> > wrote: Janet: The first thing I noticed in your photo was the screws, which on my 42 Custom were the main sources of leaks. Per the SOP from this list, I eliminated the screws and screw holes by replacing each lens. With the lens removed, I cleaned up the cavities first using a putty knife to remove old sealant then using wire brushes, shop rags, and acetone. I also filled the screw holes with an epoxy mixture. Once the holes were filled and the cavity was fully clean, I applied 3M double-sided tape and put each replacement lens in place using the “tape hinge” method. After that, the Dow 795 is used. My windows haven’t leaked since (10 years or so). Matt From: Janet Schilling via CnC-List <[email protected] <mailto:[email protected]> > Sent: Saturday, November 1, 2025 8:01 PM To: Stus-List <[email protected] <mailto:[email protected]> > Cc: Janet Schilling <[email protected] <mailto:[email protected]> > Subject: Stus-List Fwd: Deglazing port lights Oops. Forgot the photo. <image001.jpg> Sent from my iPhone Begin forwarded message: From: Janet Schilling <[email protected] <mailto:[email protected]> > Date: November 1, 2025 at 7:49:10 PM EDT To: Stus-List <[email protected] <mailto:[email protected]> > Subject: Deglazing port lights Reply-To: Stus-List <[email protected] <mailto:[email protected]> > Here’s a close up of the old dried out - and missing in places - glazing on my 1980 C&C MKI. Looking for recommendations for cleaning it out so I can mask off and deglaze with Dow 795. What tools/techniques work best? TIA!! Janet Schilling Sent from my iPhone Your contributions help pay the fees associated with this list and help to keep it active. Please help by making a small contribution using PayPal at: https://www.paypal.com/paypalme/stumurray All contributions are greatly appreciated.
Your contributions help pay the fees associated with this list and help to keep it active. Please help by making a small contribution using PayPal at: https://www.paypal.com/paypalme/stumurray All contributions are greatly appreciated.
