Dear Cobalt developers and cobalt experts, I put a Adaptec scsi card 2940 in the 2nd pci slot of my cube 2 (it is a gateway cube, which is identical to a cobalt cube 2, with a 2nd PCI slot).
I'm wondering how I can find out if the card works with my cube 2 ?. Do I have to compile my own kernel ? Can I use this card to connect a dat tape drive ? The serial port output shows the following: ----- Cobalt Microserver Diagnostics - 'We serve it, you surf it' Built Tue May 25 15:58:41 PDT 1999 1.LCD Test................................PASS 2.Controller Test.........................PASS 5.Bank 0:.................................16M 6.Bank 1:.................................16M 7.Bank 2:.................................16M 8.Bank 3:.................................16M 9.Serial Test.............................PASS 10.PCI Expansion Slot....................**Unknown Card** 12.IDE Test................................PASS 13.Ethernet Test...........................PASS 16.RTC Test................................PASS BOOTLOADER ramcode: selected partition /dev/hda1 Decompressing done Executing bootloader kernel... Decompressing -\ done. ----- Which brings me two my second problem. After decompressing -\ done, the cube boots further without problems, but the serial console is dead. I can't log in (only by telnet). Does anyone know what is wrong. I thought you can use the serial port to log in ? I appreciate any thoughts or help Frank Mattes Department of Virology Royal Free Hospital London __________________________________________________ Do You Yahoo!? Send FREE video emails in Yahoo! Mail! http://promo.yahoo.com/videomail/ _______________________________________________ cobalt-developers mailing list [EMAIL PROTECTED] http://list.cobalt.com/mailman/listinfo/cobalt-developers
