Manny wrote:
For the card slot fan, where does one plug the power cord on a RaQ 550's
board?
I don't see any extra "fan power pins" ... perhaps splice into existing
fan
power wires?
Manny
Manny, the ones I got had both ends on them so I just add it to my hard
drive power supply
BTW, they have been running over two years now....great produce for a U1
rack
Best Regards, Jon McCauley
The 550's HD's are on sleds, which slides the HD's connectors into the
connectors afixed on the motherboard. The power supply's connectors connect
to the board also. I don't see where I would be able to plug the card slot
fan's power connector to ... darn, I would love to able to use this on a RaQ
550.
Manny
Manny,
I just remembered after your post what I did for my raq 4s was remove
the connector end off the fan/spliced the wires and pulled the power
hard drive plug from the hard drive. I then carefully pulled the pins
from the end and added the fan wires to the pin set them put back the
plug together.
Best Regards, Jon McCauley
_______________________________________________
Cobaltfacts site list
[email protected]
http://list.cobaltfacts.com/mailman/listinfo.cgi/cobaltfacts
