Mariusz Gronczewski написав(ла): > Hi > 2009/10/27 Янченко Игорь <[email protected]>: >> Hello, >> >> I use collectd for monitoring swiches with big traffic around 800M-1G. I >> have next problem: >> when I set Interval 300, collectd write into rrd complete nonsense >> values. But when I set short interval (like 10) I get correct values. >> >> I also use mrtg for monitoring, for correct values in mrtg I write >> ":::::2" after ip in config, like this: >> >> Target[10.10.100.5_Vl111]: #Vl111:[email protected]:::::2 >> >> mrtg have interval 300 and write correct values with this string. >> >> >> >> Sorry for my bad english. >> > My first thougth is that counter gets full and wrapped around more > than one time between checks but then if mrtg gets it right... unless > mrtg have some way of detecting how much counter overflows was between > checks > > Regards > Mariusz
I'm not expert in snmp, however I know, snmp version 2c supports 64 bit counter instead 32 bit. And mrtg use it when I insert in config ::::2. But I don't understand how I can use it in collectd. -- С Уважением, Янченко Игорь email: mailto:[email protected] jabber: xmpp://[email protected] SKIF ISP IGR0-UANIC _______________________________________________ collectd mailing list [email protected] http://mailman.verplant.org/listinfo/collectd
