kasjer commented on a change in pull request #2017: WIP - P-NUCLEO-WB55 URL: https://github.com/apache/mynewt-core/pull/2017#discussion_r328963733
########## File path: hw/mcu/stm/stm32wbxx/include/mcu/stm32wbxx_mynewt_hal.h ########## @@ -0,0 +1,66 @@ +/* + * Licensed to the Apache Software Foundation (ASF) under one + * or more contributor license agreements. See the NOTICE file + * distributed with this work for additional information + * regarding copyright ownership. The ASF licenses this file + * to you under the Apache License, Version 2.0 (the + * "License"); you may not use this file except in compliance + * with the License. You may obtain a copy of the License at + * + * http://www.apache.org/licenses/LICENSE-2.0 + * + * Unless required by applicable law or agreed to in writing, + * software distributed under the License is distributed on an + * "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY + * KIND, either express or implied. See the License for the + * specific language governing permissions and limitations + * under the License. + */ + +#ifndef __MCU_STM32WB_MYNEWT_HAL_H +#define __MCU_STM32WB_MYNEWT_HAL_H + +#include "stm32wbxx.h" +#include "stm32wbxx_hal_dma.h" +#include "stm32wbxx_hal_gpio.h" +#include "stm32wbxx_hal_i2c.h" +#include "stm32wbxx_hal_spi.h" + +#ifdef __cplusplus +extern "C" { +#endif + +/* Helper functions to enable/disable interrupts. */ +#define __HAL_DISABLE_INTERRUPTS(x) \ + do { \ + x = __get_PRIMASK(); \ + __disable_irq(); \ + } while(0); + +#define __HAL_ENABLE_INTERRUPTS(x) \ + do { \ + if (!x) { \ + __enable_irq(); \ + } \ + } while(0); + + +int hal_gpio_init_stm(int pin, GPIO_InitTypeDef *cfg); +int hal_gpio_deinit_stm(int pin, GPIO_InitTypeDef *cfg); + +struct stm32_hal_i2c_cfg { + I2C_TypeDef *hic_i2c; + volatile uint32_t *hic_rcc_reg; /* RCC register to modify */ + uint32_t hic_rcc_dev; /* RCC device ID */ + uint8_t hic_pin_sda; Review comment: for UART pins were int8_t ---------------------------------------------------------------- This is an automated message from the Apache Git Service. To respond to the message, please log on to GitHub and use the URL above to go to the specific comment. For queries about this service, please contact Infrastructure at: [email protected] With regards, Apache Git Services
