jerpelea opened a new pull request, #19638: URL: https://github.com/apache/nuttx/pull/19638
## Summary Two sequencing problems in the MMC wide bus path break eMMC 4-bit operation on hosts that program the bus width in the SDIO widebus / clock callbacks (e.g. STM32H7): 1. The SWITCH command (CMD6) is issued before the host has switched to wide bus operation. When the card completes the switch while the host is still in 1-bit mode the switch never takes effect and every following data transfer times out. Switch the host to wide bus operation before issuing CMD6. 2. The transfer clock is selected only at the end of mmcsd_widebus(), so the whole switch sequence runs at ID-mode clock and, on the affected hosts, the final clock update does not take effect either, leaving the bus at ~400 kHz. Select the MMC transfer clock before calling mmcsd_widebus(), and pick CLOCK_MMC_TRANSFER_4BIT when wide bus operation is active (mirroring the SD card path) so a later clock selection cannot revert the host to 1-bit. No behavior change for SD cards, and no change on hosts whose widebus callback only records the requested state. Tested on a custom STM32H743 board with eMMC: sd_bench sequential write ~4.1 MB/s, sequential read ~6.3 MB/s (previously all data transfers timed out). ## Impact RELEASE ## Testing CI -- This is an automated message from the Apache Git Service. To respond to the message, please log on to GitHub and use the URL above to go to the specific comment. To unsubscribe, e-mail: [email protected] For queries about this service, please contact Infrastructure at: [email protected]
