Hi Mychaela, It's great that you have been able to build a firmware with BMI enabled! I strongly agree that Pirelli and Compal are a dead end; targeting GTA02 is a good idea considering it's much closer to the reference design and you have obtained the layout. Of course developing new hardware is the best course of action imho.
I don't currently own a GTA02 (yet), however I can still give a hand at trying to understand calibration with the hardware I have (not as good as a CMU200, but it's a start). Unfortunately I have no knowledge about board design, except that directly connecting Vdd to Gnd is a bad idea ;) To attract more developers, an idea could be to succeed at an initial PoC port to C1xx, and announce it on osmocom-bb's baseband-devel mailing list. Since all osmocom-bb users and developers currently own C1xx hardware, this might raise their interest for the project, and get them to give FreeCalypso a try. This could also generate media attention in the case of a crowdfunding campaign for hw development. What do you guys think? --DS _______________________________________________ Community mailing list [email protected] https://www.freecalypso.org/mailman/listinfo/community
