Hi, I believe the Ubuntu SDL package you're looking for is: libsdl1.2-dev You'll also need the build-essential package to compile the source.
First I tried the manual installation... http://wiki.openmoko.org/wiki/OpenMoko_under_QEMU#Manual_setup ...for which I also apt-get installed: svn gcc-3.4 monotone Then I tried the MokoMakefile installation... http://wiki.openmoko.org/wiki/MokoMakefile#Installation At the last step of each installation (openmoko/flash.sh ; make qemu), however, I received a fatal error... ... make[1]: Leaving directory `/home/moko/build/qemu/openmoko' Please wait, programming the NAND flash... neo_gsm_switch: GSM disabled. U-Boot 1.2.0-moko9_r10_9912121f7ed804ea58fd62f3f230b5dcfc357d88_0_2270 (Jun 17 2007 - 12:48:38) DRAM: 128 MB NAND: Bad block table not found for chip 0 Bad block table not found for chip 0 64 MiB *** Warning - bad CRC or NAND, using default environment Video: 640x480x8 31kHz 59Hz USB: S3C2410 USB Deviced mtdparts variable not set, see 'help mtdparts' mtdparts variable not set, see 'help mtdparts' mtdparts variable not set, see 'help mtdparts' mtdparts variable not set, see 'help mtdparts' mtdparts variable not set, see 'help mtdparts' In: serial Out: serial Err: serial pcf_write: charging in Qualification Mode. pcf_write: charge voltage 4.20V. openmoko/flash.sh: line 88: 10743 Terminated $qemu -mtdblock "$script_dir/$flash_base" -kernel "$script_dir/$1" -serial stdio -nographic -usb -monitor null 0<&0 U-boot failed to finish writing in 300 seconds, giving up. make: *** [flash-qemu-official] Error 255 [EMAIL PROTECTED]:/home/moko# CiaCon <[EMAIL PROTECTED]> wrote: > I currently am new to Linux. I currently use Ubuntu Linux > (fawn). I tried to get Qemu running with OpenMoko, but it > fails (need for SDL or Cocoa)... > As Ubuntu is one of the most used Linux-Distros, I thought a > walktrhough (starting @ 0) might be a nice idea, to get a mass > introduced to OpenMoko. This e-mail is for the use of the intended recipient(s) only. If you have received this e-mail in error, please notify the sender immediately and then delete it. If you are not the intended recipient, you must not use, disclose or distribute this e-mail without the author's prior permission. We have taken precautions to minimize the risk of transmitting software viruses, but we advise you to carry out your own virus checks on any attachment to this message. We cannot accept liability for any loss or damage caused by software viruses. _______________________________________________ OpenMoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community