I have tried this and the cursor stays with the stylus in the middle of the
screen but when you get near the top or bottom it doesnt.I have run ts_test and
get this from the draw mode https://swel024.ath.cx/~swel024/blah.png and cant
fill the top left or bottom left corners.thanksSimonDate: Mon, 6 Aug 2007
09:40:53 +0200From: [EMAIL PROTECTED]: [EMAIL PROTECTED]: Re: Touchscreen not
working properlyCC: [EMAIL PROTECTED] you boot the neo and X starts, there is a
short time you see the typical X-mousepointer and you also can move it.
You can check this way if the cursor is really at another position than your
stylus.
2007/8/6, Simon Wells <[EMAIL PROTECTED]>:
I have a Phase1 device which i have been using for a few days with no issues
until yesterday when i turned it on at one point and the touchscreen failed to
function. after advice from #openmoko i took the front cover of the phone off
to make sure there was no dust between it and the screen after doing this the
touchscreen worked again but was not going where i touched. i reran the
calibration tool and rebooted and it still doesnt go where i touch. for example
if i touch where the menu is it seems to think i am clicking about 1/4 way down
the screen. Has anyone got any hints on what the problem could be? i have also
tried flashing the firmware back onto it but it doesnt help
ThanksSimon
See what you're getting into…before you go there See it!
_______________________________________________OpenMoko community mailing
[EMAIL PROTECTED]
http://lists.openmoko.org/mailman/listinfo/community
_________________________________________________________________
See what you’re getting into…before you go there
http://newlivehotmail.com/?ocid=TXT_TAGHM_migration_HM_viral_preview_0507
_______________________________________________
OpenMoko community mailing list
[email protected]
http://lists.openmoko.org/mailman/listinfo/community
