Hello, My Freerunner fails to recognize the SD card. There are no /dev/mmc* named devices in the system. I have 2007.2 image upgraded with opkg from factory image.
Revelant part of dmesg: [EMAIL PROTECTED]:~# dmesg | grep -E "glamo|mmc" glamo3362 glamo3362.0: Detected Glamo core 3650 Revision 0002 (49119232Hz CPU / 81887232Hz Memory) glamo3362 glamo3362.0: Glamo core now 49119232Hz CPU / 81887232Hz Memory) glamo-spi-gpio glamo-spi-gpio.0: registering c0373838: jbt6k74 glamo-mci glamo-mci.0: glamo_mci driver (C)2007 Openmoko, Inc glamo-mci glamo-mci.0: probe: mapped mci_base:c8864400 irq:0. glamo-mci glamo-mci.0: glamo_mci_set_ios: power down. glamo-mci glamo-mci.0: initialisation done. mmc_set_power(power_mode=1, vdd=20 glamo-mci glamo-mci.0: powered (vdd = 20) clk: 0kHz div=255 (req: 0kHz). Bus width=0 glamo-mci glamo-mci.0: powered (vdd = 20) clk: 195kHz div=255 (req: 195kHz). Bus width=0 glamo-mci glamo-mci.0: powered (vdd = 20) clk: 195kHz div=255 (req: 195kHz). Bus width=0 glamo-mci glamo-mci.0: powered (vdd = 20) clk: 195kHz div=255 (req: 195kHz). Bus width=0 glamo-mci glamo-mci.0: Error after cmd: 0x120 glamo-mci glamo-mci.0: Error after cmd: 0x8120 glamo-mci glamo-mci.0: Error after cmd: 0x120 glamo-mci glamo-mci.0: Error after cmd: 0x8120 glamo-mci glamo-mci.0: Error after cmd: 0x120 glamo-mci glamo-mci.0: Error after cmd: 0x8120 glamo-mci glamo-mci.0: Error after cmd: 0x120 glamo-mci glamo-mci.0: Error after cmd: 0x8120 glamo-mci glamo-mci.0: Error after cmd: 0x120 glamo-mci glamo-mci.0: Error after cmd: 0x8120 mmc_set_power(power_mode=0, vdd=0 glamo-mci glamo-mci.0: glamo_mci_set_ios: power down. Also I've seen a line like this: mmc0: error -110 whilst initialising sd card Regards, Marek Materzok
_______________________________________________ Openmoko community mailing list [email protected] http://lists.openmoko.org/mailman/listinfo/community
