I rebuilded all from scratch and now i found uImage-2.6.24.xxxx, so make flash-qemu-local run successfull, howewer when i finally run make run-qemu, u-boot loads the kernel and returns to it's main menu.
I'm not expert on u-boot, howewer i added -serial stdio to qemu, it gives: U-Boot 1.3.2-moko12 (Sep 4 2008 - 17:27:20) I2C: ready DRAM: 128 MB NAND: 64 MiB Found Environment offset in OOB.. Video: 640x480x8 31kHz 59Hz NAND read: device 0 offset 0x244000, size 0x5000 Reading data from 0x248e00 -- 100% complete. 20480 bytes read: OK USB: S3C2410 USB Deviced In: serial Out: serial Err: serial neo_lcd_rst_switch: LCD reset. jbt6k74_command: Display on. neo_vib_switch: Buzz, buzz. neo_vib_switch: Vibrator stopped. neo_bl_switch: LCD Backlight now on. GTA01Bv4 # boot ## Booting kernel from Legacy Image at 30100000 ... Image Name: Openmoko/2.6.24+git1+a1e97c61125 Created: 2008-09-04 13:37:58 UTC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 1894664 Bytes = 1.8 MB Load Address: 30008000 Entry Point: 30008000 Verifying Checksum ... OK Loading Kernel Image ... OK OK ERROR: image overwritten - must RESET the board to recover. neo_gsm_switch: GSM disabled. wath can i do now? Nicola On 9/3/08, Nicola Mfb <[EMAIL PROTECTED]> wrote: > I'm working an ubuntu hh to build and test asu. > I downloaded > http://svn.projects.openmoko.org/svnroot/mokomakefile/trunk/Makefile > changed OM_GIT_BRANCH in org.openmoko.asu.stable > > after that i did make setup, make setup-machine-neo and make > openmoko-qtopia-x11-image. > The image was build successfull after several hours, but when i try to do > make flash-qemu-local i get an error saying > that is not possible to ls files in > build/tmp/deploy/glibc/images/neo1973/uImage-2.6.*-om-gta01.bin > > What do i miss? > > thanks > > Nicola > _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community