On Fri, Sep 19, 2008 at 9:45 AM, Sean McNeil <[EMAIL PROTECTED]> wrote: > > How are you copying the uImage to the sdcard? Is it possible you have > CR/LF translation on?
Have no clear idea what CR/LF translation is but I just did "sudo cp uImage /media/disk/". Usually we either do cp in a similar way or copy - paste in GUI. We use Ubuntu Linux. > > Shaz wrote: >> Hi, >> >> I am getting bad magic number when I try to boot from micro SD with my >> new uImage. I had a clean and successful make and make uImage. I have >> an first partition on SD card of 100MB (vfat) and 899MB (ext3). I am >> using the moko toolchain as the later commands show. And got the >> sources from: >> >> -------------------- >> git clone git://git.openmoko.org/git/kernel.git linux-2.6 >> cd linux-2.6 >> git checkout origin/stable >> -------------------- >> >> >> After executing the following command: >> ------------------ >> >> sudo make >> CROSS_COMPILE=/usr/local/openmoko/arm/bin/arm-angstrom-linux-gnueabi- >> ARCH=arm uImage >> >> ------------------ >> I got the following output: >> ------------------ >> . >> . >> . >> >> Image Name: Linux-2.6.24 >> Created: Fri Sep 19 06:58:28 2008 >> Image Type: ARM Linux Kernel Image (uncompressed) >> Data Size: 1769300 Bytes = 1727.83 kB = 1.69 MB >> Load Address: 0x30008000 >> Entry Point: 0x30008000 >> Image arch/arm/boot/uImage is ready >> ------------------- >> >> What are the possible reasons for bad magic number and what is the solution? >> >> > -- Shaz _______________________________________________ Openmoko community mailing list [email protected] http://lists.openmoko.org/mailman/listinfo/community
