Here is the output. I can see the access point but it is not connected even though in Mofi the circle is orange next to the access point.
[EMAIL PROTECTED]:~# iwconfig eth0 eth0 AR6000 802.11g ESSID:"" Mode:Managed Bit Rate:1 Mb/s Tx-Power=0 dBm Sensitivity=0/3 Retry:on Encryption key:off Power Management:off Link Quality:0/94 Signal level:-95 dBm Noise level:-96 dBm Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 [EMAIL PROTECTED]:~# iwlist eth0 scan eth0 Scan completed : Cell 01 - Address: 00:0F:66:D2:BB:41 ESSID:"linksys" Mode:Master Frequency:2.437 GHz (Channel 6) Quality=15/94 Signal level=-80 dBm Noise level=-95 dBm Encryption key:off Extra:bcn_int=100 ----- Original Message ----- From: "Vince M. Clark" <[EMAIL PROTECTED]> To: "List for Openmoko community discussion" <community@lists.openmoko.org> Sent: Thursday, October 2, 2008 11:00:18 PM (GMT-0700) America/Denver Subject: Re: FDOM and WiFi eth0 definitely has no address. I'll check iwconfig. ----- Original Message ----- From: "Alex Osborne" <[EMAIL PROTECTED]> To: "List for Openmoko community discussion" <community@lists.openmoko.org> Sent: Thursday, October 2, 2008 10:55:46 PM (GMT-0700) America/Denver Subject: Re: FDOM and WiFi Vince M. Clark wrote: > If I open a terminal and run ifconfig all I have is > eth0, lo, and usb0. The wifi is eth0. Is there an address associated with it there? Also check the output of "iwconfig". If it has associated the AP then it should say "Access Point:" and then give the MAC address of the AP. _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community
_______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community
