Am Dienstag, den 02.12.2008, 01:13 +0100 schrieb Maelvon HAWK: > You put me on the right way, I've forgot to change the "ext2load mmc" > to "fatload" with the "rootfstype=vfat". So now it works with vfat. >
I guess I was wrong. It should be 'rootfstype=ext2' and 'fatload mmc 1 0x32000000' in the NAND boot menu. But better you crosscheck on your own with your device (see below). Here is how to figure out what may cause the trouble at your site: To see the differences between the NOR and NAND boot-entries first power on the FR once with the combination "AUX then PWR" (NOR-Boot). Connect the usb-cable with your Desktop-PC and connect to the FR with your favorite terminal program [1]. Type "printenv" in the terminal. Write down (copy/paste ;-) ) the values for menu_1=... Power down the FR (type "neo1973 power-off" in the terminal). Start it again with "PWR then AUX" to bring the NAND bootloader up. Connect with your favorite terminal program (i prefer minicom), type printenv again and compare/adjust the values you wrote down from NOR. good luck, Marian [1] http://wiki.openmoko.org/wiki/MacOS_X#Connecting_a_Mac_and_an_Openmoko_device _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community