-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Somebody in the thread at some point said: | Em Sab, Dezembro 27, 2008 04:06, Kosa escreveu: |> I've been trying to boot 2008.12 from a microsd but it just can't. |> It starts booting but then it stops with an "Only GTA01 hardware |> supported by ASoc driver" message. | | Happens to me also, but after that message I also have the following | messages (not sure if they change from boot to boot): | | Unknown HZ value! (87) Assume 100. | mount: special device /dev/mmcblkp01 does not exist | ALSA: restoring mixer settings... | Configuring network interfaces... /usr/sbin/alsactl: load_state:1327: No | soundcards found... | ADDRCONF(NETDEV_UP): usb0: link is not ready | done. | | I can shutdown by holding the power button. | I have FDOM in the same card and it works fine.
I was just meddling with this in NAND, I believe that "ro" on the kernel commandline is fatal for startup of 2008.12. When I removed it from Qi, 2008.08 started up OK. So check your U-Boot env if you're using that for "ro", or try adding rw to /boot/append-GTA02 if you are on SD Card and Qi. It's pretty common to boot with rootfs ro initially... - -Andy -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.9 (GNU/Linux) Comment: Using GnuPG with Fedora - http://enigmail.mozdev.org iEYEARECAAYFAklaL68ACgkQOjLpvpq7dMpdZwCfY23A6BvOiEu/OQx2bRnJh3A5 cJkAn2Mu/MbFjCdP9MIcdIqWAMpeHCYD =Nm0M -----END PGP SIGNATURE----- _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community