Hello, I can't make openocd work with my neo. I checked carefully cables, use several usb port and have mainly test with a self-powered hub. When I plug the usb cable in the debug board or launch openocd, the screen of the neo flashes white. Sometimes, it just stay white when plugging the board on the pc. Is-it a good behaviour ?
I try to use openocd with this configuration, and tried with changing speed to 0,4,8 : telnet_port 4444 gdb_port 3333 interface ft2232 jtag_speed 0 ft2232_vid_pid 0x1457 0x5118 ft2232_layout "jtagkey" reset_config trst_and_srst jtag_device 4 0x1 0xf 0xe daemon_startup attach target arm920t little reset_run 0 arm920t working_area 0 0x200000 0x4000 backup run_and_halt_time 0 5000 You can found the output of openocd here : http://pastebin.com/m2e2b52b9 The version of openocd I tried was the ubuntu one, and the static one made by bitbake with the fso-makefile configuration. -- Frederic Leroy _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community