I had the same problems with the same image. But today, when i tried to connect to the network of my university, it surprisingly worked. I did the following: powered up the device with shr-settings and started mofi.py in the terminal. It worked fine until i switched the device off. So, I hope that was no one-night-stand with me and eth0! But your troubles make me worry!
Hope anyone can help! Matthias Adam Jimerson schrieb: > I am still trying to get my wireless to work on the 4/16 release of > SHR-Testing, I can get a scan to work on eth0 every now and then and > the rest of the time I get a "device does not support scanning > error". No matter if I can scan or not eth0 will not connect to any > AP. I have set up the /etc/network/interfaces so that eth0 uses > wpa_supplicant, which I have the file setup with the APs and > everything, and when I try and ifup eth0 it goes though the > configurations but stops at a "No lease failing" error. I have been > at this for a while trying to get it to work and all my attempts have > failed. If anyone has any kind of suggestion, or if they have had > this problem with this version of SHR-Testing please reply, I getting > desperate and will try anything to get it to work. > ------------------------------------------------------------------------ > > _______________________________________________ > Openmoko community mailing list > [email protected] > http://lists.openmoko.org/mailman/listinfo/community > _______________________________________________ Openmoko community mailing list [email protected] http://lists.openmoko.org/mailman/listinfo/community
