Am 14.12.2009 um 13:04 schrieb Neil Jerram: > 2009/12/12 Lothar Behrens <lothar.behr...@lollisoft.de>: >> >> I always need to fiddle the USB cable into the neo and this could >> then >> avoided. > > I used to think that. I eventually realised that the real problem was > that I have to force charging at 500mA. Could that be the case for > you too? >
No, I simply have sometimes to fiddle the cable into the neo before starting the engine. It would be very nice if there are two contacts in the size of the small fingernail. Then one simply need to 'clip' it into a housing with counterpart contacts. The USB cable therefore is in the clip housing and it should have mounting device similar to those swan neg navigarion holder. Then the original device could be replaced by this device. Maybe someone could use blender to design such a device. I am only capable to design the electronics using KICAD. Another option would be a Wing drawing to be used as a electronic part for KICAD. I don't know if anyone has done similar parts to appear more like a housing. Regards, Lothar > Regards, > Neil > > _______________________________________________ > Openmoko community mailing list > community@lists.openmoko.org > http://lists.openmoko.org/mailman/listinfo/community > -- | Rapid Prototyping | XSLT Codegeneration | http://www.lollisoft.de Lothar Behrens Heinrich-Scheufelen-Platz 2 73252 Lenningen _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community
