Well, I've been trying my darnedest to get the sd card in my phone to mount as a USB drive. I have been Googling and trying to use this guide from the wiki to no avail: http://wiki.openmoko.org/wiki/Using_the_Neo_as_an_USB_Mass_storage_device
When I try to mount the /media/card I get an error that it's not found. Fair enough, I run 'fdisk -l' and the only information listed is my internal drive. I was able to see that the device is recognized by my computer: [ 1959.576070] usb 4-2: new full speed USB device using uhci_hcd and address 3 [ 1959.791253] usb 4-2: configuration #1 chosen from 2 choices [ 1959.800462] eth2: register 'cdc_ether' at usb-0000:00:1d.2-2, CDC Ethernet Device, 00:1f:11:01:13:f6 The next step, I then run 'rmmod g_ether', that module isn't existent. So through dmesg I find the driver which is active, and I tried disabling that: "rmmod cdc_ether" This is the only command which didn't give me an error message. On the last command (modprobe g_file_storage file=/dev/mmcblk0 stall=0), I get the output: FATAL: Error inserting g_file_storage (/lib/modules/2.6.32-21-generic/kernel/drivers/usb/gadget/g_file_storage.ko): Unknown symbol in module, or unknown parameter (see dmesg) After checking dmesg again, I now see: [ 1830.381547] g_file_storage gadget-lun0: unable to open backing file: /dev/mmcblk0 I'm nearly at my wits end here. I don't have access to a card reader, and I tried setting up 3 different phones (non-FR's) as USB drives, but each one has it's own unique issue. So I'm left hoping someone out there may be able to help me out with this. I would really appreciate any ideas you all may have. Thanks in advance! - Woody _______________________________________________ Openmoko community mailing list [email protected] http://lists.openmoko.org/mailman/listinfo/community
