to be honest. Mokonnect rarely worked for me. I would also suggest u to use wpa_supplicant or similar wifi tools. Usually I turn on wifi using the shr settings ui and then run wpa_supplicant and udhcpc. That works 99% of the time if the interface is up.
Good luck On Mon, Apr 26, 2010 at 11:17 AM, HansV <h...@vanpee.be> wrote: > > [quote]Wifi seems unavailable, but after seeking the ML I found there is a > bug > in FSO MS5 (MS5 is the revision ?) and I had to do : > echo s3c2440-sdi >/sys/bus/platform/drivers/s3c2440-sdi/unbind > echo s3c2440-sdi >/sys/bus/platform/drivers/s3c2440-sdi/bind > in order to get eth0 back. [/quote] > > I entered the commands above and eth0 is available now. But Mokonnect still > doesn't work, even after rebooting the FR. It says: > Wifi device seems to be off, trying to power it on... > This message takes forever. When the FR goes in standby the Wifi symbols is > shown in the top-shelf. > In Settings->Connectivity I can't change the WiFi setting, it always stays > in 'Automatic'. > > After the reboot I had to enter the above commands again to get eth0 back. > The error message is now followed by: > Failed powering on the device or it was still not found in connman. > -- > View this message in context: > http://openmoko-public-mailinglists.1958.n2.nabble.com/SHR-U-Wifi-stopped-working-tp4562468p4961739.html > Sent from the Openmoko Community mailing list archive at Nabble.com. > > _______________________________________________ > Openmoko community mailing list > community@lists.openmoko.org > http://lists.openmoko.org/mailman/listinfo/community > _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community
