On Fri, May 14, 2010 at 5:36 PM, Dr. H. Nikolaus Schaller <h...@computer.org>wrote:
> > > > However, you may also want to consider making the parts directly, > > without going via a cast. This is much more expensive for larger > > quantities, but if you only need a handful of cases anyway, it > > should be more efficient. > > The alternative would be 3D-Printing. There are now some quite good > machines that can produce in ABS. Unfortunately these machines are > rather expensive and operators want to have fast amortization. This > raises cost of small quantities of cases like the freerunner well > beyond 100 USD. > Have you contacted any hackerspaces? Check this non-exhaustive list http://harkopen.com/hackerspaces -- --------------------------------------------------------- Atilla Filiz Eindhoven University of Technology Embedded Systems, Master's Programme --------------------------------------------------------
_______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community