On 10/21/2010 07:59 PM, Alfa21 wrote: > you should try 3d print like this: <snip> > made in ABS which is a good plastic and up to 0.01 inches resolution
Unfortunately, that's not quite good enough (different units). 0.01 inches = 0.254 mm, which is 2.54 times the required size: On 10/21/2010 07:32 PM, Dr. H. Nikolaus Schaller wrote: > the required precision (0.1 mm, 0.5 mm wall thickness, etc.) 0.1 mm is approximately 0.0039 inches. I have a question, though - is this precision required for making *any* well-working case design (due to the electronics etc.), or is it just for making more of the current case design? If it's the latter, it would be possible to create a new case design that would be easier to get manufactured... -- Regards, EdorFaus _______________________________________________ Openmoko community mailing list [email protected] http://lists.openmoko.org/mailman/listinfo/community
