Hi David, Michael, all, > Hi > >> It looks like you will need to convince the maintainer of Qtmoko to >> tell you (and the rest of us) how to get his popular distro working >> with FreeCalypso tools. Or you could try the special distro which >> David Matthews put together - the 2nd version which works without the >> special cable. > Making a general purpose distro such as Qtmoko loadtools capable is likely to > be a non starter. As well as stopping everything that's accessing the modem - > which will likely be the problem Giacomo reported - it's likely to be > advisable to rip out all the audio stuff also. > > hehe - So prepare your qtmoko (by ripping it to shreds), run loadtools to > flash your calypso, then reinstall and recover your data from backups :-)
It's been easier than expected: root@neo:~# . /opt/qtmoko/qpe.env root@neo:/root# /etc/init.d/qtmoko-neo stop root@neo:/mnt/nfs/root/ModemFFS/Backup# fc-loadtool -h gta02 /dev/ttySAC0 Sending beacons to /dev/ttySAC0 Toggling /sys/bus/platform/devices/gta02-pm-gsm.0/power_on Got beacon response, attempting download <p command successful, switching to 115200 baud Sending image payload ............................................................................................................................................................................................................................................................................................................................................................Sending checksum <c command successful, sending <b <b command successful: downloaded image should now be running! FreeCalypso loadagent running Loaded via UART 0 (MODEM) at baud rate #0 TCXO clock input autodetected to be 26 MHz Executing init script k5a3281.init Script command: w16 fffffb00 00A3 Script command: w16 fffffb02 00A3 loadtool> flash dump2bin my-flashdump.bin Requesting initial CRC-32 of the area from target... got 95D5AB43 Requesting memory dump... Rx 4194304 out of 4194304 bytes (100%) Requesting another CRC-32 of the area from target... match, dump successful root@neo:/mnt/nfs/root/ModemFFS/Backup# /etc/init.d/qtmoko-neo start Now I'm looking at it with mokoffs :-) Thank you very much, Giacomo > > Better idea - use the "special distro" (I used Qtmoko as a starting point) > with or without the cable - or else build your own single purpose > boot_and_run_from_sdcard system. > > http://winterveldt.co.za/leo2moko-p2.html > -- > David Matthews > m...@dmatthews.org > -- > David Matthews > m...@dmatthews.org > > _______________________________________________ > Openmoko community mailing list > community@lists.openmoko.org > http://lists.openmoko.org/mailman/listinfo/community -- ############################################################## giacomo 'giotti' mariani gpg --keyserver pool.sks-keyservers.net --recv-key 0x99bfa859 O< ASCII ribbon campaign: stop HTML mail www.asciiribbon.org ############################################################## _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community