Am 03.03.2014 12:46, schrieb Matthias Apitz:
Hi,
I'm struggling a bit with qtmoko and Wifi configs, maybe because I'm new
to qtmoko and more used to use FreeBSD systems;
I'd like to configure a small set of Wifi zones (where I'm normaly in);
in FreeBSD I just expand the file /etc/wpa_supplicant.conf with the
required values about WPA-PSK, PSK, etc. and all is fine; my netbook
picks up the best of each location when I start Wifi there; and I do not
have to enter anything when I go from location A to B;
How do I do this in qtmoko? I could finaly manage to configure my own AP
at home, say location A; where I could see around 8 other neighbour AP
which I'm not interested in to connect; then I moved to location B and
the FR offered me the 8 AP of location A (which of course are not
visible due to the distance between A and B), and in addition around 8
AP of location B; I could not manage to pick-up the correct AP by its
SSID, maybe due to the long list; and had to remove all config
"Internet" and start from scratch for location B; this is soemhow
boring. Is there an easy config file to pick-up only the AP's I do know
(in the sense of credentials)?
Or do I do something stupid wrong?
matthias
Hi,
take a look at "Settings-> Internet->WLAN->Properties->WLAN Roaming".
There You can setup the order of used WLAN's and if You like to stay
connected and so on....
--
Kind regards
Sebastian Reinhardt
_______________________________________________
Openmoko community mailing list
community@lists.openmoko.org
http://lists.openmoko.org/mailman/listinfo/community
