I have uploaded a design at <http://home.earthlink.net/~gamba2/rcnetwork.html> It addresses some of the issues raised by Jeff Walther. It's a bit of a kludge though, i.e.,soldering chip caps into a vertical position, and the wire pins would need inspection for resoldering after network is soldered into motherbboard. I haven't, and will not, look up part numbers for chip caps and resistors because where I buy them locally doesn't sell them by part number.
Gamba <http://home.earthlink.net/~gamba2> >If you're discussing an alternative for the "filter" that causes failure >of the serial ports when it goes South, that *IS* very interesting. Can >someone come up with plans to make a substitute? I have two SE/30 mobo's >with one or both serial ports shot. >Rob -- Compact Macs is sponsored by <http://lowendmac.com/>. Support Low End Mac <http://lowendmac.com/lists/support.html> Compact Macs list info: <http://lowendmac.com/lists/compact.shtml> The FAQ: <http://macfaq.org/> --> AOL users, remove "mailto:"; Send list messages to: <mailto:compact.macs@;mail.maclaunch.com> To unsubscribe, email: <mailto:compact.macs-off@;mail.maclaunch.com> For digest mode, email: <mailto:compact.macs-digest@;mail.maclaunch.com> Subscription questions: <mailto:listmom@;lemlists.com> Archive:<http://www.mail-archive.com/compact.macs%40mail.maclaunch.com/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
