I bought 2 sets of four 16 MB 30 pin SIMMS for use in an SE/30. I cannot get one set to work at all. The other set will only work if I install the four 16 MB SIMMS in bank A and then fill bank B with 1 MB SIMMS. If I install just the four 16 MB SIMMS in either bank A or bank B the machine will not even start up- all I get is a lighted screen with vertical lines spaced about 1/2 inch apart, no sad mac, no start up tones, just the lighted screen. Here's another oddity, when I boot the computer with the 16 MB and 1 MB SIMMS it takes about a minute to go from the happy mac screen to the welcome to macintosh screen. With any other combination of 1 MB and 4 MB SIMMS the time between these screens is about 2 -3 seconds.
If anyone has a valid explanation for all of this I would appreciate it. Thanks, chemtechman -- Compact Macs is sponsored by <http://lowendmac.com/>. Support Low End Mac <http://lowendmac.com/lists/support.html> Compact Macs list info: <http://lowendmac.com/lists/compact.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/compact.macs%40mail.maclaunch.com/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
