This one time, at band camp, Tom Lee said:

> > > however, it still would experience 'sticktion' half the time at boot
> > > up. i solved that problem by oiling the spindle.  not recommended, i
> > > know, but these old drives have exposed mechanical parts that allow
> > > this kind of remedy without much risk of contaminating the inner
> > > platter chamber.
>
> You're lucky: stiction is rarely caused by motor bearing lube problems.
> Much more commonly, the head actually glues itself to the disk surface
> (they coat the platters with a very thin material to reduce wear when
> the heads land on them at power down). That kind of stiction has no
> practical solution besides whacking of varying degrees of violence. The
> 3.5" 40MB and 80MB Quantum drives failed from this problem very
> frequently, and so did the Sony drives (which is why Sony got out of the
> HD business soon after). I've done lots of post-mortems on these, and
> the platter surface feels tacky, unlike modern drives that don't have
> this problem. In one case, the head was glued on so tightly that
> spinning the platter manually was amazingly hard to do (and it mangled
> the head).
>
> --Tom

yup.  i have an identical drive in an SE, and it suffers from platter
sticktion.  it's not too bad.  if it's been off for more than a couple of
days, it requires a bit of a shake to get it going.  oil didn't help much
for this drive.

jj


-- 
Compact Macs is sponsored by <http://lowendmac.com/>.

      Support Low End Mac <http://lowendmac.com/lists/support.html>

Compact Macs list info: <http://lowendmac.com/lists/compact.shtml>
  --> AOL users, remove "mailto:";
Send list messages to:  <mailto:[EMAIL PROTECTED]>
To unsubscribe, email:  <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive:<http://www.mail-archive.com/compact.macs%40mail.maclaunch.com/>


---------------------------------------------------------------
>The Think Different Store
http://www.ThinkDifferentStore.com
---------------------------------------------------------------

Reply via email to