I had a similar problem on a cheapo ($7) laser printer from the Salvation
Army. A little bit of fingernail polish remover (or some kind of acetone)
cleaned it up after some vigorous rubbing. You will have to dismantle the
printer a bit to get to those tight spots. Of course it smells all girly
now, bot the feed tray works. I'm sure that straight acetone would work much
better, but I like to use what I have on hand, to save money at all costs. I
didn't sand paper them, just cleaned of the hard outer dry rubber enough to
get some pick up.

Peter


-- 
Compact Macs is sponsored by <http://lowendmac.com/>.

      Support Low End Mac <http://lowendmac.com/lists/support.html>

Compact Macs list info: <http://lowendmac.com/lists/compact.shtml>
  --> AOL users, remove "mailto:";
Send list messages to:  <mailto:[EMAIL PROTECTED]>
To unsubscribe, email:  <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive:<http://www.mail-archive.com/compact.macs%40mail.maclaunch.com/>


---------------------------------------------------------------
>The Think Different Store
http://www.ThinkDifferentStore.com
---------------------------------------------------------------

Reply via email to