Re: Are SE and SE/30 screws the same?

[Susan Platter]

This is all helpful stuff, thank you.  I've been offered a dead SE, so 
was hoping to be able to reuse the chassis screws at least.  I didn't 
understand the reference to "sheet metal" and "4-40", though. Can you 
please translate for the technically challenged?

Susan Platter
Swindon, Wiltshire
England
On 28 Jun, 2004, at 20:00, Compact Macs wrote:
Date: Mon, 28 Jun 2004 10:36:15 -0700
Subject: Re: Are SE and SE/30 screws the same?
From: "J.S. Garrison" <[EMAIL PROTECTED]>
Message-ID: <[EMAIL PROTECTED]>
In-Reply-To: <[EMAIL PROTECTED]>
on 6/28/04 7:40 AM, Snook, John R at [EMAIL PROTECTED] 
wrote:

Well, that is quite funny, because it is the inner screws in 
particular
that I want to know about! Can anyone help, please?

Susan Platter
Swindon, Wiltshire
England
0000000000000000000000000000000000000000000000000
Hi, The inner screws are the same, except the screws that hold the 
analogue
board on are sometimes sheet metal and sometimes 4-40.
johnsn
~~~~~~~~~~~~~~~~~~~~
To qualify that, the screws holding the CRT to the frontplate are 
shorter
than the rest.

If you use longer screws in the CRT holes you'll likely see 4 dimples 
in the
face of your Mac around the CRT.

Jeff G

--
Compact Macs is sponsored by <http://lowendmac.com/>.
     Support Low End Mac <http://lowendmac.com/lists/support.html>
Compact Macs list info: <http://lowendmac.com/lists/compact.shtml>
 --> AOL users, remove "mailto:";
Send list messages to:  <mailto:[EMAIL PROTECTED]>
To unsubscribe, email:  <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive:<http://www.mail-archive.com/compact.macs%40mail.maclaunch.com/>
---------------------------------------------------------------
The Think Different Store
http://www.ThinkDifferentStore.com
---------------------------------------------------------------