The Powerconnect 3048 (a 48 port stackable switch) can connect via web, or via RS232 to the console port. Have you looked at the user manual? You can also view/download it from http://support.dell.com/support/edocs/network/2T180/en/index.htm According to the installation section you need to connect to the console port (after initial installation) to set up the switch (especially the IP address so that you could use the web interface - not also that when reloaded the default factory config it does not reload/change the IP address, mask and default gateway addresses). Also when posting to google groups an http with ip address it is best to split it up since google masks it and the entire address cannot be seen (such as http://192.168.1.1 vs http:// 192.168.1.110).
On Aug 24, 10:29 am, Seanmff <[email protected]> wrote: > How do you configure the Dell Powerconnect 3048. I am unable to > through the web interface that is (http://192.....) Any help with this > device would be greatly appreciated. --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Computer Tech Support" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/computer-tech-support?hl=en -~----------~----~----~----~------~----~------~--~---
