> ----- Original Message ----- > From: Tomasz Bursztyka > Sent: 04/08/14 07:18 AM > To: [email protected] > Subject: Re: 'Not supported' message > > Hi, > > > I'm sending four attachments to your email to avoid mailing to the list. > > But I think I have the reason why I had no wifi; Connman is soft blocking > > the card when it starts. > > If I unblock using rfkill, I can scan and connect! Log 1 is with card > > blocked, Log 2 after I unblock. > > > > So how is this? How is it solved? > > This is the normal behavior: first start, connman blocks all > technologies but ethernet. Blocks = set powered off. > Then if you power on the technology, connman will remind it. > > According to connmanctl your wifi technology was powered, can you verify > that: if wifi card is soft rfkill, connman still shows that? > Bug is there then.
Right the situation is this. If I run: 'wpa_supplicant -u -ddt'(with or without log) the supplicant starts then 'connmand -n -d' from the connman source; connman starts and scans Then, from another terminal, 'connmanctl scan wifi': I can then connect. There is no soft blocking. But if I run 'wpa_supplicant -Dnl80211 -iwlan0 -c/etc/wpa_supplicant.conf' and then 'connmand -n -d' from the connman source, I get the familiar 'Error /net/connman/technology/wifi: Not supported' Again there is no soft blocking anymore - why I don't know. Where should I go now? thanks Cliff _______________________________________________ connman mailing list [email protected] https://lists.connman.net/mailman/listinfo/connman
