Hi,
On Sat, 2015-02-28 at 01:12 +0000, Thomas Green wrote:
> I've been seeing a dhcp issue lately that perhaps you can explain. I
> am using wireshark to watch the dhcp transaction progressing. I am on
> the wired (eth0) connection. I send a dhcp request, and I get two
> dhcp ack packets with the address info. Then I see a dhcpv6 request
> and response. However when I do ifconfig on my device I only have
> ipv6 information. I never get the IPv4 dict item in my events, only
> the IPv6 dict.
>
> This is only happening when I boot my system.
>
> If I go and make a dhcp request again (via a SetProperty call),
If a SetProperty call gets DHCP running, what might the previous value
of IPv4 Method be? In what state are the services after boot
('connmanctl services' and 'connmanctl services ethernet_XXXXX....') ?
> everything goes fine, and I get the IPv4 dict in my PropertyChanged
> event, and ifconfig now displays the received IPv4 address.
Cheers,
Patrik
_______________________________________________
connman mailing list
[email protected]
https://lists.connman.net/mailman/listinfo/connman
