Hi,
On Fri, 2015-08-14 at 16:33 +0100, Alejandro Gonzalez wrote:
> I run connman with gdb and I tried to get the backtrace, it wasn't very
> useful because it crash in different place all time. It try to access to
> use the dhcp in the IPv4 for the Ethernet interface, but the structure is
> gone it make signal 11 (segmentation fault) or signal 10 (error the use the
> BUS) when it try to use the socket in IPv4 for the Ethernet. It's logical
> because it depend if the memory was reused or not in the moment of the
> access to this elements.
You are now seeing something else than upstream crashing or then you
have a very specific set of conditions that I can't reproduce. Signal 10
is SIGUSR1 and sent by some external entity. Something fishy is
happening with your system.
Nobody else is seeing anything like this, so check again if there are
any additional patches on top and that your Yocto build environment is
set up correctly, is sane and works with the architecture you're using.
Especially since it is crashing in different place all the time as you
describe.
Cheers,
Patrik
_______________________________________________
connman mailing list
[email protected]
https://lists.connman.net/mailman/listinfo/connman
