Hi,
> Ok I might have screwed this up in burning the CD because I couldn't
> boot by holding C, but no problem I used the open firmware to boot into
> yaboot.
My PowerBook stopped booting from the CDs after I updated the firmware, so
I don't think the inability to boot from a CD is necessarily an indication of
a bad burn.
> This is where the problems are, I press enter to run the default
> install, it says "Loading kernel...." then stops and says "Image not
> found" and goes back to" boot>". Anyone know where I went wrong? Did I
> burn the CD wrong or is something else not working?
Instead of pressing enter to accept the default boot option, hit the tab
key to display all the available boot options. I don't know what video card
your Mac uses, but "install-aty128fb" works for me on both an iMac and
Powerbook. Do any of them work for you?
See ya'
Phil
