Pieter,
I had a problem similar to this, especially when I set the
eth0 to use DHCP. The solution lay in changing the domain I specified
in netconf: specifically, leaving it blank. One thing you might try is
doing a
dhcpcd -H -D -d
to set the hostname and domainame properly. -d should show
any debug information
(also, you might have to install the dhcpcd rpm)
Hope this helps,
-M.A.Behr
Pieter wrote:
>
> Hello all
>
> my current place is that eth0 fails during boot, after boot doing a
> modprobe 3c509 and the eth0 is working, but not like it should. No ip
> address assigned if i do that manually (even if the adapter needs dhcp) i
> can ping outside my network. But dns (even if i entered nameserver in
> resolve.conf) doesnt work.
>
> So im getting a crippled eth0, and no Internet connection. While i think it
> should work ??
>
> regards,
>
> Pieter
