http://qa.mandrakesoft.com/show_bug.cgi?id=1942
[EMAIL PROTECTED] changed:
What |Removed |Added
----------------------------------------------------------------------------
Status|UNCONFIRMED |RESOLVED
Resolution| |DUPLICATE
------- Additional Comments From [EMAIL PROTECTED] 2003-03-17 23:45 -------
*** This bug has been marked as a duplicate of 1881 ***
------- You are receiving this mail because: -------
You are on the CC list for the bug, or are watching someone who is.
------- Reminder: -------
assigned_to: [EMAIL PROTECTED]
status: RESOLVED
creation_date:
description:
When going through the drakconnect wizard on laptops (IBM T21 and T30) with an
wireless nic + a buildin ehternet card, everything worx during configuration.
However
When you get back to the drakconnect start screen in the mandrake control
center, if i click "Ok" the wireless eth1 configuration get flushed and i wind
up with only the original eth0 configuration for the ethernet card.
When i instead, back in the drakconnect start screen, click cancel, both
configurations are retained :)
Minor bug but some wont figure it out ;)
By the way
ACPI worx flawless on an IBM T30 laptop
